Opticosol Solution

Adult use

Used according to the prescribed method based on the type of surgery. Use an intravenous infusion set with an air inlet in the plastic spike according to the specific infusion set being used. Remove the plastic flip-off cap and clean and disinfect the rubber stopper with alcohol before inserting the spike through the center of the rubber stopper in a sterile manner. Remove air before infusing the solution.

This drug should be used with caution if there are abnormalities in the corneal endothelium, as it may cause blisters on the cornea or inflammatory disease due to irrigation or trauma. This drug may cause damage to the cornea and other ocular tissues, so the prescribed dosage and administration must be strictly followed in all surgical procedures. This drug should only be used as an irrigation solution during ophthalmic surgery and must never be used for intravenous injection. This drug does not contain preservatives, so it should not be reused after one use, and it should not be used if the solution is cloudy or if a vacuum state is not maintained. Mixing this drug with other medications may damage ocular tissues, so mixing should be avoided. Do not remove the packaging until preparation for use is complete, as the packaging has waterproof properties, and the inner bag maintains the solution in a sterile state. After removing the packaging, the inner bag should be pressed to check for leaks for several minutes, and if a leak is found, it should be discarded due to the risk of contamination. This drug should be stored at room temperature, and it is important to avoid excessive heat during storage.

Mild side effects

Potential for blistering and inflammatory corneal disease when there are abnormalities in the corneal endothelium.

This drug should be stored in a sealed container to prevent exposure to air, and the storage temperature should be maintained between 8 degrees and 27 degrees. This will keep the drug's effectiveness safely for a long time.

Appearance

A colorless and transparent liquid contained in a colorless and transparent glass or polypropylene, multilayer film plastic material infusion container.

Package unit

500mL/bottle, 500mL/bag